I welcome you all to today's tutorial on how to service a mobile phone that fell into water.
Without taking much of your time i will love to discuss briefly why you need to service your phone immediately after it fell into water or water mistakenly splash on it.

Reason why you should service a phone that fell into water
Phones are made of several components such as "diode, capacitor, integrated circuit," etc. These components does not like water. Any moment your phone fell into water this components will start absorbing the water and in return your phone panel will began to rust slowly until when it finally damaged the panel though it takes time but you need to service your phone before then. 
So what are the things you need to service a phone that fell into water.

Requirements
1). Brush, i recommend toothbrush
2). Petrol or spirit
3). Phone screw driver and picker

How to service an Android phone that fell into water
1). Remove your sims and memory card
2). Unscrew the phone using phone screw driver
3). Use your finger or plastic rubber to open the phone from side, be careful and do it gently
4). Unclip and detach the calibrator, screen, battery, cameras from the panel, and be mindful of the power switch with other flex you see.
5). Bring out the panel and search for "mouthpiece".
6). Use your hand to cover the surface of the mouthpiece.
7). Deep your brush inside petrol or spirit and start servicing the panel, scrub gently and make sure your brush touches every part excluding mouthpiece, cameras and speakers.
Note: if your battery is soldered then you will need to desold it using soldering iron, and if you don't have soldering iron no need to worry you can still scrub your panel without unsoldering the battery.
8). Dry your panel under sunlight for some minutes and return everything back to it position.
9). Tie the screw gently, don't use force.
10). Turn on your phone and enjoy.

Watch video here:

How to service a button phone that fell into water
1). Remove the battery, sims and memory card
2). Unscrew the phone using phone screw driver
3). Use your finger or plastic rubber to open the phone from side, be careful and do it gently
4). Remove the bouncer leather from the panel and place it some where.
5). Bring out the panel and be careful with mouthpiece, camera, speakers, radio (wires).
Note: if any of the above wires cut while dismantling, then you will need to solder it back using a soldering iron.
6). Deep your brush inside petrol or spirit and start servicing.
7). Don't allow petrol or spirit to enter inside ("mouthpiece, camera and speakers").
8). Dry your panel under sunlight for some minutes and return everything back to it position.
9). Tie the screw gently, don't use force.
10). Turn on your phone and enjoy.

Watch video here:


Do you find this post helpful? If yes please don't forget to drop your comment and share!!!

0 Comments